GE AF-650 GP Programming Manual page 102

Parameter Descriptions
O-17 Configurable Alarm and Warningword
The configurable alarm and warning word has 16 bits (0-15).
Each of those bits can be configured to any of the following
options.
Option:
[10081] CSIV corrupt alarm
[10082] CSIV param error alarm
[10090] Feedback monitor alarm
[10091] AI54 settings alarm
[10164] ATEX ETR current lim alarm
[10166] ATEX ETR freq limit alarm
O-19 Product Code
Range: Function:
0 [0 - 2147483647] Select 0 to read out the actual fieldbus
*
product code according to the mounted
fieldbus option. Select 1 to read out the
actual vendor ID.
3.10.3 O-3# Drive Port Settings
Parameters to configure the GE drive port.
O-30 Protocol
Option: Function:
[0] Drive Communication according to the Drive
Protocol.
[1] Drive MC Select the protocol for the drive (standard)
port.
[2] Modbus RTU
*
O-31 Address
Range: Function:
1 [1 - 255] Enter the address for the Drive (standard) port.
*
Valid range: 1–126.
O-32 Drive Port Baud Rate
Option: Function:
[0] 2400 Baud Baud rate selection for the Drive (standard)
port.
[1] 4800 Baud
[2] 9600 Baud
*
[3] 19200 Baud
[4] 38400 Baud
[5] 57600 Baud
[6] 76800 Baud
[7] 115200 Baud
O-33 Drive Port Parity
Option: Function:
Parity and stop bits for the protocol
parameter O-30 Protocol using the Drive
port. For some of the protocols, not all
DET-618D
AF-650 GP™ Programming Guide
O-33 Drive Port Parity
Option:
Function:
[0] Even Parity, 1
*
Stop Bit
[1] Odd Parity, 1
Stop Bit
[2] No Parity, 1 Stop
Bit
[3] No Parity, 2 Stop
Bits
O-34 Estimated cycle time
Range:
0 ms
*
1000000 ms]
O-35 Minimum Response Delay
Range:
10 ms
*
O-36 Max Response Delay
Range:
10001
ms
*
O-37 Max Inter-Char Delay
Range:
25.00
ms
*
3.10.4 O-4# Drive MC Port Settings
Parameters to configure the standard telegram or custom
telegram for the GE drive port.
02/2016 All rights reserved.
Function:
options are visible. Default depends on
the protocol selected.
Function:
[0 - In noisy environments, the interface may
be blocked due to overload or bad frames.
This parameter specifies the time between
2 consecutive frames on the network. If the
interface does not detect valid frames in
that time, it flushes the receive buffer.
Function:
[1 - 10000 Specify the minimum delay time
ms] between receiving a request and
transmitting a response. This is used for
overcoming modem turnaround delays.
Function:
[11 - Specify the maximum permissible delay
10001 ms] time between transmitting a request
and receiving a response. If a response
from the frequency converter is
exceeding the time setting, then it is
discarded.
Function:
[0.00 - Specify the maximum permissible time
35.00 ms] interval between receipt of 2 bytes. This
parameter activates timeout if transmission
is interrupted.
This parameter is active only when
parameter O-30 Protocol is set to [1] Drive
MC protocol.
3 3
101