Which Parameters Are Restored To Default Values After Default Settings Are Operated; Exporting Data - Huawei NetCol5000-C Series User Manual

NetCol5000-C(065, 080) In-row Chilled Water Smart
Cooling Product
User Manual
7.1.18 Which Parameters Are Restored to Default Values After
Default Settings Are Operated
After choosing Settings > Restore Defaults > Comfirm, the following parameters are
displayed:






To prevent key data from being lost, you are recommended to record all parameter values or
back up data with export configurations before restoring defaults. Then change the parameter
values back to the recorded values after restoring defaults. For details about how to use export
configurations, see

7.1.19 Exporting Data

Context
With the one-click mode, you can export active alarms, historical alarms, run logs, and so on.
You are advised to use the FAT32 USB flash drive with a capacity no greater than 64 GB.
Format the non-FAT32 USB flash drives into FAT32 ones before using them.
Before using a USB flash drive, ensure that its data has been scanned by antivirus software
and is secure.
Issue 07 (2020-03-16)
All parameters displayed on Settings > System Settings.
All parameters displayed on Settings > Alarm Settings.
All parameters displayed on Settings > Comm Settings.
All parameters except for language and time settings displayed on Settings > Quick
Settings.
Date format and time zone settings displayed on Settings > User Settings.
All parameters displayed on Maint > Sensor Calibration.
7.1.19 Exporting
After default settings are restored, all communication addresses are changed to 1 and the communication
between all devices and the EMS is disconnected. The communication addresses must be reset to
recover the communication.
 Before exporting active alarms, historical alarms, logs, and configurations, ensure that the USB flash
drive has been successfully identified. The USB port is located on the side of the screen.
 If the USB flash drive has been successfully identified,
 If the USB flash drive is not properly connected, the system will display No USB device found.
during operations about the USB flash drive.
Copyright © Huawei Technologies Co., Ltd.
Data.
is displayed in the status bar.
7 FAQ
193