Replacing An Ibat - Huawei FusionModule2000 V500R003C10 Maintenance Manual

FusionModule2000 Smart Modular Data Center
Maintenance Guide
Figure 5-44 Removing an iBOX (from a battery rack)
Step 4 Clamp the new iBOX to the fastener.
Step 5 Reconnect cables to the iBOX based on the cable labels.
Step 6 Synchronize the parameters of the iBOX on the ECC800 WebUI.
Step 7 On the WebUI of the ECC800, choose Monitoring > System > ECC800 > Controls >
Delete device with communication failure, and click Submit.
Step 8 Hold down the networking switch on the iBOX for 2s. The RF_Z indicator on the iBOX
changes from steady green to blinking green at super short intervals (on for 0.05s and then off
for 0.05s), which indicates that the iBOX is being networked.
Step 9 Hold down the iBAT networking switch for 2s. When the RUN/ALM indicator changes from
steady red to blinking green at short intervals, and finally to blinking green at long intervals,
the iBAT connects to the iBOX network.
Step 10 Hold down the networking switch on the iBOX for 2s. When the RF_Z indicator on the iBOX
changes from blinking green at super short intervals to blinking green at long intervals, the
networking is complete.
Step 11 Confirm that each iBAT reports information properly.
----End

5.4.4.2 Replacing an iBAT

An iBAT needs to be replaced when it is faulty or fails in communication. If multiple iBATs
need to be replaced, replace them in ascending order based on battery numbers in the range of
0–300.
Impact on the System
The operation data of the battery managed by the iBAT cannot be monitored.
Preparations


Issue 04 (2020-01-03)
 It is recommended that iBATs be networked from the positive battery string terminal according to
the battery cable connection sequence.
 The sequence of connecting the iBAT to the iBOX determines the battery number.
Material: iBAT
Skill requirement: power distribution engineers
Copyright © Huawei Technologies Co., Ltd.
5 Parts Replacement
86