Huawei FusionModule2000 V500R003C10 Maintenance Manual page 63

FusionModule2000 Smart Modular Data Center
Maintenance Guide
Figure 5-5 Removing the ECC800 main control module
Step 5 (Optional) Remove the Micro SD card and SIM card from the corresponding slots on the side
of the ECC800 main control module.
Step 6 (Optional) Install the removed Micro SD and SIM card in the corresponding slot of the new
ECC800 main control module.
Figure 5-6 Installing the Micro SD and SIM card
Step 7 Install the spare ECC800 main control module in the ECC800 subrack and tighten the screws
on both sides of the ECC800 main control module.
Step 8 Connect the communications cables, WiFi module, and antennas to the ECC800 main control
module.
Step 9 Choose Maintenance > Configuration File and import the backup configuration file, or set
parameters for the devices that connect to the ECC800 to ensure normal communication.
----End
Issue 04 (2020-01-03)
If the ECC800 is connected to the NetEco, delete the ECC800 that fails to communicate with the NetEco
and add a new ECC800.
Copyright © Huawei Technologies Co., Ltd.
5 Parts Replacement
56