Replacing The Vcn510 Hard Disk - Huawei FusionModule2000 V500R003C10 Maintenance Manual

FusionModule2000 Smart Modular Data Center
Maintenance Guide
Figure 5-12 Installing Device
Step 4 Reconnect the cables to the new VCN510.
Step 5 Turn on the power switch of the VCN510.
Step 6 Commissioning the VCN510. If the video recording function works properly after
commissioning, the VCN510 is functional.
----End

5.4.2.2 Replacing the VCN510 Hard Disk

Prerequisites




Context
Recommended tools and materials: Phillips screwdriver, ESD wrist strap (or ESD gloves).
Procedure
Step 1 Put on an ESD wrist strap (or ESD gloves) and insert the ground terminal into the ESD jack in
the cabinet.
Step 2 Remove the faulty hard disk.
1.
Issue 04 (2020-01-03)
The hard disk needs to be replaced.
Data in the hard disk has been backed up.
A spare hard disk of the same model is available and functional.
Before replacing a faulty disk, ensure that the power switch on the rear panel is off and
disconnect the power cable to power off the device.
Use a Phillips screwdriver to loosen three fastening screws on the left and right of the
subrack cover.
Copyright © Huawei Technologies Co., Ltd.
5 Parts Replacement
61