❑
Press [Next].
❑
Select the desired paper type ➞ press [OK].
If you want to adjust the thickness of the toner applied to the paper, press
[Plain Ppr Print Set.]. If too much toner is being applied to the paper, press
[Thin]. If not enough toner is being applied to the paper, press [Heavy].
If the desired paper type is not displayed, press [Detailed Settings] ➞ select
the paper type from the list ➞ press [OK].
If you are printing onto the back side of a previously printed sheet, press [2nd
Side of 2-Sided Page].
● If you want to select an envelope size:
❑
Press [Envelope].
❑
Select the desired envelope type ➞ press [OK].
IMPORTANT
•
If the envelope type is not set correctly, a paper jam will occur.
•
If you use envelopes that have glue attached to their flaps, the glue may melt due to
the heat and pressure of the fixing unit.
❑
Press [OK].
The paper size/type currently loaded and the paper size/type reserved to be
loaded are displayed, as shown on the screen below.
NOTE
If there is more than one reserved job waiting to print, only the last paper size/type
specified for the reserved print job is shown on the Paper Select screen.
4
Press [Done].
This completes the settings for reserving a print job using the stack bypass. The
subsequent steps show you how to start printing and load paper into the stack
bypass.
5
Press [Start Print].
The last paper size/type specified
for the reserved print job
The paper size/type currently
loaded
Reserving Jobs
2
2-39