Copying
1
Place your originals ➞ press [Special Features] ➞ [Margin].
2
Select the desired margin type.
3
Select [Front Side] or [Back Side] ➞ press [-] or [+] to set the
margin width ➞ press [OK].
IMPORTANT
•
If you are using the Margin and 2-Sided modes together and copying an original
that already has margins, follow the instructions below:
- 1 2-Sided: Set the margin for the back only.
- 2 2-Sided: You do not need to set a margin. Proceed to make copies in the usual
way.
- 2 1-Sided: Set the margin for the back only.
•
If you are using the Margin and 2-Sided modes together and copying an original
that does not have a margin, follow the instructions below:
- 1 2-Sided: Set the margin for both the front and back.
- 2 2-Sided: Set the margin for both the front and back.
- 2 1-Sided: Set the margin for both the front and back.
NOTE
If you enter a value other than 0, you can switch between positive and negative
margin width by pressing [±].
Example:
➞
(+)10
[±]
➞
-50
[±]
➞
-10
➞
(+)50
Margin Mode
4
4-39