■ Copying
1
2
3
4
4
4-64
Using Image Creation Modes
Place your originals on the platen glass ➞ press [Special
Features] ➞ [Image Creation].
Press [Area Designation] ➞ press [Pen Entry].
Press [Start Scan].
IMPORTANT
Confirm that the original is placed on the platen glass.
Designate the area using the edit pen.
IMPORTANT
You cannot designate a rectangular area and a polygonal area at the same time.
NOTE
•
To clear the last point entered, press [Erase Point]. (Once an area is designated,
[Erase Point] changes to [Clear Area].)
•
To clear a designated area, press [Clear Area].
To zoom in on any area on the original, press the ratio drop-down list ➞ select an
•
enlargement ratio ➞ press [ ], [ ], [ ], or [ ] to display the desired area.
● To designate a rectangular area with two points:
❑
Designate two opposing points with the edit pen.
You can designate up to four different areas.