Setting Up A Dial-Up Connection To An Alarm Station; Figure 11-6 Area Code Needed To Connect To A Multi-Media Alarm Station - Honeywell Rapid Eye System Administration Manual

Setting Up a Dial-Up Connection to an Alarm Station

Document 800-07769 Rev A
02/11
1. Add or update an alarm station definition (as explained in
Reports, page 216). The IP Address field is left empty for a dial-up
Name and
connection to an alarm station, except if a remote access service (RAS) server—apart
from the alarm station—is part of the connection. For RAS servers, see
Connection to an Alarm Station
2. Select the Use Dial-up Networking option.
3. Leave the Country Code as (dialing same country), unless the Multi-Media
unit is in a different country than the alarm station.
Caution Honeywell recommends using the (dialing same country) option.
Do not use your country's name, such as United States of America (1),
unless the alarm station is in a different country from the Multi-Media unit.
Figure 11-6 Area Code Needed to Connect to a Multi-Media Alarm Station
4. Enter the alarm station's area code in the Area Code (City Code) field.
5. Enter the alarm station's telephone number in the Phone Number field.
6. Enter the alarm station's PPP User Name and PPP Password in their fields.
These can be obtained from your network administrator, as indicated in Overview,
page 215.
7. Enter the PPP password a second time in the Confirm PPP Password field.
8. Click Save and Close. In the Alarm Stations tab's Connection Method column, a
(d) appears, standing for dial-up, followed by the telephone number that calls the
Multi-Media alarm station.
9. To finish preparing the alarm station, see
page 231.
Rapid Eye DVR System Administrator Guide
on page 229.
Making an Alarm Station Operational
Adding an Alarm Station
RAS
on
223