Setting Up A Dial-Up Connection To An Alarm Station; Figure 11-6 Area Code Needed To Connect To A Multi-Media Alarm Station - Honeywell Rapid Eye Administrator's Manual

Setting Up a Dial-Up Connection to an Alarm Station

Document 800-02953V4 Rev A
03/10
Microsoft Windows
To send alarms over a dial-up connection, you will need to obtain a point-to-point protocol
(PPP) username and password for the PC used as an alarm station, or for its RAS server,
from their Microsoft Windows operating system. See
an Alarm Station's Definition
1. Add or update an alarm station definition (as explained in
Name and Reports, page 218). The IP Address field is left empty for a dial-up
connection to an alarm station, except if a remote access service (RAS) server—apart
from the alarm station—is part of the connection. For RAS servers, see
Connection to an Alarm Station
2. Select the Use Dial-up Networking option.
Leave the Country Code as (dialing same country), unless the Multi-Media
3.
unit is in a different country than the alarm station.
Caution Honeywell recommends using the (dialing same country) option.
Do not use your country's name, such as United States of America (1),
unless the alarm station is in a different country from the Multi-Media unit.
Figure 11-6 Area Code Needed to Connect to a Multi-Media Alarm Station
4. Enter the alarm station's area code in the Area Code (City Code) field.
5. Enter the alarm station's telephone number in the Phone Number field.
Rapid Eye Multi-Media DVR System Administrator Guide
Point-to-Point Protocol (PPP) Fields in
on page 220.
on page 231.
Adding an Alarm Station
RAS
225