Replacing A Unit; Replacing A Unit When A System Password Is Enabled; Figure 10-5 Use The Lvp Utility When A Unit Replaces Another - Honeywell Rapid Eye System Administration Manual

Replacing a Unit

Replacing a Unit when a System Password Is Enabled

TIP!
Document 800-07769 Rev A
02/11
New Unit
When you replace a Multi-Media unit at a site with a new unit from the factory, the factory
unit's last valid password (LVP) is blank.
Use LVP Utility to Match Site Definition
If you replace a Multi-Media unit and your Multi-Media database is set to a system password
(see Password, page 182), you need to use the LVP utility to match the site
System
definition to the blank password on the unit.
Figure 10-5 Use the LVP Utility when a Unit Replaces Another
This unit replacement procedure only applies when you replace a unit at a site that
has already been defined and is operational.
The procedure does not apply to adding a new site to your Multi-Media system. To simply
add a site to your system, see
1. Check that the Multi-Media unit is powered-up at the site.
2. Using Admin, update the site's definition (see
3. Click LVP (last valid password). A Reset Last Valid System Password dialog box
appears. Note the asterisks in the unit Password and Confirm Password fields.
Rapid Eye DVR System Administrator Guide
on page 35.
Adding a Site
Updating a Site
Use the LVP utility to replace
a unit at a secured site. Use
the utility to delete the
asterisks (*) that represent
the system password used at
that site.
on page 37).
189