Changing The Maximum Network Data Rate; Tcp Ports; Default System Values For A Multi-Media Unit; Table 8-2 Default Network Communications Settings - Honeywell Rapid Eye System Administration Manual
Hide thumbs
Also See for Rapid Eye:
- Administrator's manual (294 pages) ,
- System administrator manual (264 pages) ,
- Operator's manual (150 pages)
Table of Contents
Advertisement
TIP!
Changing the Maximum Network Data Rate
TCP Ports
Default System Values for a Multi-Media Unit
Document 800-07769 Rev A
02/11
Changing the Internet protocol address, in the IP Address box requires Admin to
change the site's connection information. See
page 41.
Table 8-2
Default Network Communications Settings
Box
IP Address of Multi-Media Unit
Subnet Mask
Gateway
a
These values are usually changed when installing units connected to a network. For
more information about networked units, see the Network Connections section in the
Rapid Eye™ Multi-Media Digital Video Recorder Installation
The operator enters the Maximum Network data rate, to Send no more than n kilobits per
second, where n is a number between 10 and 200 000. Note that some numbers are not
ideal to lower the data rate optimally and are automatically adjusted by the software to the
closest, better value. For example, if an operator enters 33, the software will display the
closest optimal value (32), at the next
1.
Using View, continue or start a
2.
On the System tab, enable the Regulate Data Rate checkbox and enter a number in
the field. The default setting is 32.
The transmission control protocol (TCP) ports are listed in the
Digital Video Recorder Installation
for sockets used in Multi-Media operations. For example, Multi-Media sessions (live,
retrieval and alarm) are sent to port 10,000.
Table 8-3
System Tab Default Values
Box Group
Name of Box/Button
Site Info
Serial Number
Software
Upgrade button
Network Settings
Use DHCP
Site Name. See the sticker
on the unit.
Rapid Eye DVR System Administrator Guide
Connecting to a Rapid Eye Unit
a
Value
172.25.2.1
255.255.0.0
172.25.100.4
Maintenance
Session.
for the Rapid Eye site.
Maintenance Session
Guide. These TCP ports should be left open in a firewall
Default
a
N/A
; stored on unit
a
N/A
; stored on unit
None
Enabled
a
N/A
; stored on unit, for DHCP use.
Format: REM serial number
on
Guide.
Rapid Eye™ Multi-Media
149
Advertisement
Table of Contents
