Frame Rate Setting; Table 5-1 Frame Rate Values (Approximate Ips) For Multi-Media Units - Honeywell Rapid Eye System Administration Manual
Hide thumbs
Also See for Rapid Eye:
- Administrator's manual (294 pages) ,
- System administrator manual (264 pages) ,
- Operator's manual (150 pages)
Table of Contents
Advertisement
Video Feed Setup
TIP!
Frame Rate Setting
80
2.
Select a value (pixels × pixels) from the list. For comments about the values, see
Optimizing Recorded
page 89. The default values are 320 × 240 (NTSC) and 384 × 288 (PAL).
Honeywell recommends optimizing the resolution of recorded video using the
Automatic Performance Maximization.
Caution
Honeywell does not recommended gauging the resolution of recorded
video based on live video. Live video is always shown at an optimal
resolution that could differ from the recording resolution.
1.
On the Recording tab, click a cell in the Frame Rate column.
2.
Select an images per second (ips) value from the drop-down list that appears. The
default value is 1 ips.
Note
The following frame rate values have been calculated using CIF resolution. If
the resolution is raised, frame rates may have to be lowered.
Table 5-1
Frame Rate Values (Approximate IPS) for Multi-Media Units
NTSC
1
2
PAL
1
2
Frame Rates on Multi-Media Units
Rapid Eye 480/400 IPS units.
maximum frame rate setting of 480 ips at CIF resolution (for NTSC units, 400 ips for PAL
units). This maximum frame rate can be divided among connected cameras however
needed. For example, each of 16 cameras can be set to 30 ips, or 8 cameras can be set to
60 ips, and so on. To automatically set the maximum frame rate and resolution of your
system, see
Making Optimized Resolution and Frame Rate Settings
Rapid Eye 120/100 IPS units.
maximum frame rate setting of 120 ips at CIF resolution (for NTSC units, 100 ips for PAL
units). This maximum frame rate can be divided among connected cameras however
needed. For example, each of 16 cameras can be set to 7.5 ips, or 8 cameras can be set to
15 ips, and so on. To automatically set the maximum frame rate and resolution of your
system, see
Making Optimized Resolution and Frame Rate Settings
Rapid Eye LT units.
Rapid Eye LT units have a maximum frame rate setting of 120 ips at
CIF resolution (for NTSC units, 100 ips for PAL units). This maximum frame rate can be
divided among connected cameras however needed. For example, each of 8 cameras can
Video, page 83, and
Recorded Video Resolution Reference
3
4
5
6
3
4
5
6
This section applies to Rapid Eye units that have a
This section applies to Rapid Eye units that have a
7.5
10
15
30
8
12.5
25
on page 84.
on page 84.
on
Advertisement
Table of Contents
