Rapiddome Mimic Tour; Testing A Mimic Tour On A Rapiddome Camera; Rapiddome Preset Tour - Honeywell Rapid Eye System Administration Manual
Hide thumbs
Also See for Rapid Eye:
- Administrator's manual (294 pages) ,
- System administrator manual (264 pages) ,
- Operator's manual (150 pages)
Table of Contents
Advertisement
Pan, Tilt, and Zoom (PTZ) Setup
RapidDome Mimic Tour
Testing a Mimic Tour on a RapidDome Camera
RapidDome Preset Tour
104
3.
Click a button in the row of numbered buttons above the drop-down list.
1.
While using View, select a site that has one or more RapidDome PTZ cameras.
2.
Run a
Session; click the Video tab.
Maintenance
3.
Select a dome camera.
4.
Click PTZ. Check if the Driver is RapidDome/Orbiter. If not, this procedure cannot be
used. In the Tour Programming section, Mimic Tour is selected by default. See
6-11. You have the option of selecting which of the four mimic tours you plan to
Figure
setup. To do so, click the drop-down arrow above the End button. A list appears,
showing Tour 1, Tour 2, Tour 3, and so on, by default. Select an item in the list.
5.
Click Program. The message Tour Programming in progress ... appears below
the buttons in the Tour Programming section (see
6.
Pan, tilt and zoom the camera, as needed.
7.
Click End.
8.
After the tour is programmed, you can:
•
Click Test to test the mimic tour.
•
Rename the mimic tour. Click inside the box in the Tour Programming section.
Enter a name. Save the name by clicking the mouse outside of the box.
9.
You have the option of programming another mimic tour for the dome camera; repeat
to
7, as needed.
step 5
step
1.
While using View, select the site at which you have programmed a mimic tour on a
RapidDome camera, as shown in
2.
Run a
Session. On the Video tab, select the dome camera that is
Maintenance
programmed with a mimic tour.
3.
Click PTZ. Check if the Driver is RapidDome/Orbiter. If not, the wrong camera or site
may have been selected and this procedure cannot be used.
4.
In the Tour Programming section, select a mimic tour, using the drop-down arrow
above the End button. By default, they are named Tour 1, Tour 2, Tour 3, and so on.
5.
Click Test.
Have some presets programmed before setting up a preset tour. See
on page 99.
on a PTZ Camera
Figure
6-11.)
Tour, page 104.
RapidDome Mimic
Configuring a Preset
Advertisement
Table of Contents
