Setting the System Clock Manually
TIP!
Adjusting the Clock on a PC Running Rapid Eye Software
Using a PC Clock to Set a Unit Clock Manually
Message
indicating that
the unit time and
PC time are NOT
synchronized.
Message
indicating that
the unit time and
PC time ARE
synchronized.
Document 800-07769 Rev A
02/11
A Multi SA can synchronize the clock of a Rapid Eye Multi-Media unit using a PC's clock as
reference. This is more useful for units connected only by dial-up, but can also be used for
units on a LAN.
Check/set the clock on an operator's PC before setting a unit clock manually.
To adjust the PC time, date and time zone:
1.
Click Start
Control Panel
2.
Check the accuracy of the time and the time zone on the PC and adjust it as needed.
1.
Using the View application, select a Multi-Media unit whose clock needs to be set.
2.
Start a
Maintenance
Session.
3.
Click the Time tab. If Manual is not selected, click it. The Time tab appears as in
Figure
4-4.
4.
Click Set Multi-Media unit's clock.
Figure 4-4
Manually Setting a Multi-Media Unit Clock
Synchronizing Time Over Dial-Up
Due to the nature of dial-up connections, the Multi-Media unit's time may still be off by a few
seconds after synchronizing it.
Rapid Eye DVR System Administrator Guide
Date and Time.
Click to
synchronize the
Multi-Media
unit's time with
your PC.
67