Refreshing A Local Database While Running View; Deleting A Database; Cannot Open A Database - Honeywell Rapid Eye System Administration Manual

Refreshing a Local Database while Running View

Deleting a Database

Cannot Open a Database

TIP!
Document 800-07769 Rev A
02/11
1. Launch View. At the Logon, confirm that there is a checkmark in the checkbox for the
Central database is accessible from this PC option.
• If so, proceed with the logon.
• If not, check with your Multi SA if the PC used to run View can connect to the PC
or server holding the Multi-Media Central database. If the answer is affirmative,
select the checkbox next to The Central database is accessible from this PC.
2. While View is running, operators can either:
• Click on the View toolbar.
- or -
• Click the Refresh command on the View menu.
Note See your Multi-Media system administrator, if this procedure fails.
You can delete a Central database at any point. Note that after deleting a Central database,
users can still connect to sites, using their local database. Attempting to refresh the local
database causes an error after the Central database is deleted.
Protecting the Multi-Media Database
On some installations, the Multi-Media central database may need to be protected from
copying and deletion. See
Possible reasons for not being able to open the database:
• The Multi-Media central database has been deleted.
• Unavailability of a network connection to the Multi-Media database.
Check the network's status. When using Admin, this error has the side effect of
creating a new, central database that has the same name as the regular database.
Rapid Eye DVR System Administrator Guide
Multi-Media Database Security
on page 180.
275