Chapter 6
Configuring WLANsWireless Device Access
Using the CLI to View a Client's CCX Version
To see the CCX version supported by a particular client device, enter this command:
show client detail mac-addr
Enabling WLAN Override
By default, access points transmit all defined WLANs on the controller. However, you can use the
WLAN Override option to select which WLANs are transmitted and which ones are not on a per access
point basis. For example, you can use WLAN override to control where in the network the guest WLAN
is transmitted or you can use it to disable a specific WLAN in a certain area of the network.
Using the GUI to Enable WLAN Override
Follow these steps to enable the WLAN Override option.
Click Wireless to access the Wireless page.
Step 1
Click 802.11a Radios or 802.11b/g Radios under Access Points to list the corresponding access points.
Step 2
Click the Configure link for the desired access point.
Step 3
Choose Enable from the WLAN Override drop-down box to enable this option and display a list of the
Step 4
available WLANs (see
Figure 6-8
Check the check boxes for the WLANs you want this access point to broadcast.
Step 5
Click Apply to commit your changes.
Step 6
Click Save Configuration to save your changes.
Step 7
Using the CLI to Enable WLAN Override
To enable the WLAN Override option using the controller CLI, enter this command:
config ap wlan enable {802.11a | 802.11b} cisco_ap
To define which WLANs you wish to transmit, enter this command:
config ap wlan add {802.11a | 802.11b} wlan-id cisco_ap
OL-1926-06OL-9141-03
Figure
6-8).
802.11a Cisco APs > Configure Page
Cisco Wireless LAN Controller Configuration Guide
Configuring WLANs
6-25