Configuring CCX Radio Management Features
Using the CLI to Obtain CCX Radio Management Information
Use these commands to obtain information about CCX radio management on the controller.
1.
2.
3.
4.
Use these commands to obtain radio management debug information for the controller.
1.
2.
3.
Cisco Wireless LAN Controller Configuration Guide
10-32
To see the CCX broadcast location measurement request configuration for all access points
connected to this controller in the 802.11a or 802.11b/g network, enter this command:
show advanced {802.11a | 802.11b} ccx global
To see the CCX broadcast location measurement request configuration for a particular access point
in the 802.11a or 802.11b/g network, enter this command:
show advanced {802.11a | 802.11b} ccx ap Cisco_AP
To see the clients configured for location calibration, enter this command:
show client location-calibration summary
To see the RSSI reported for both antennas on each access point that heard the client, enter this
command:
show client detail client_mac
To debug CCX broadcast measurement request activity, enter this command:
debug airewave-director message {enable | disable}
To debug client location calibration activity, enter this command:
debug ccxrm [all | error | warning | message | packet | detail {enable | disable}]
To debug the output for forwarded probes and their included RSSI for both antennas, enter this
command:
debug dot11 load-balancing
Chapter 10
Configuring Radio Resource ManagementWireless Device Access
OL-1926-06OL-9141-03