Overriding Dynamic Rrm - Cisco SD2008T-NA Configuration Manual

Configuring Dynamic RRM
Table 10-1
Step 2
make any desired changes.
Table 10-1 RRM Parameters
Parameter
RF Group
Group Mode
Cisco Wireless LAN Controller Configuration Guide
10-16
lists and describes the configurable RRM parameters. Follow the instructions in the table to
Description
Determines whether the controller participates in an RF group.
Options: Enabled or Disabled
Default: Enabled
Group Mode Description
Enabled
Disabled
Note
Chapter 10 Configuring Radio Resource ManagementWireless Device Access
The controller automatically forms an RF group with
other controllers. The group dynamically elects a leader
to optimize RRM parameter settings for the group.
The controller does not participate in automatic RF
grouping. Rather, it optimizes its own access point
parameters.
Cisco recommends that controllers participate in automatic RF
grouping. However, you can disable this feature if necessary by
unchecking the check box. Note also, however, that you
override dynamic RRM settings without disabling automatic
RF group participation. See the
section on page 10-23 for instructions.

"Overriding Dynamic RRM"

OL-1926-06OL-9141-03