Running The Configuration Wizard On The Cli - Cisco SD2008T-NA Configuration Manual

Using the Configuration Wizard

Running the Configuration Wizard on the CLI

When the controller boots at factory defaults, the bootup script runs the configuration wizard, which
prompts the installer for initial configuration settings. Follow these steps to enter settings using the
wizard on the CLI.
Note To configure the controller in the Catalyst 3750G Integrated Wireless LAN Controller Switch, Cisco
recommends that you use the GUI configuration wizard that launches from the 3750 Device Manager.
Refer to the Catalyst 3750G Integrated Wireless LAN Controller Switch Getting Started Guide for
instructions.
Connect your computer to the controller using a DB-9 null-modem serial cable.
Step 1
Open a terminal emulator session using these settings:
Step 2
•
•
•
•
•
Step 3 At the prompt, log into the CLI. The default username is admin and the default password is admin.
Step 4 If necessary, enter reset system to reboot the unit and start the wizard.
Step 5 The first wizard prompt is for the system name. Enter up to 32 printable ASCII characters.
Enter an administrator username and password, each up to 24 printable ASCII characters.
Step 6
Enter the service-port interface IP configuration protocol: none or DHCP. If you do not want to use the
Step 7
service port or if you want to assign a static IP Address to the service port, enter none.
If you entered none, enter the service-port interface IP address and netmask on the next two lines. If you
Step 8
do not want to use the service port, enter a fictitious IP address that is not routable anywhere on your
network.
Step 9 Enter the management interface IP Address, netmask, default router IP address, and optional VLAN
identifier (a valid VLAN identifier, or 0 for untagged).
Enter the Network Interface (Distribution System) Physical Port number. For the controller, the possible
Step 10
ports are 1 through 4 for a front panel GigE port.
Enter the IP address of the default DHCP Server that will supply IP Addresses to clients, the
Step 11
management interface, and the service port interface if you use one.
Enter the LWAPP Transport Mode, LAYER2 or LAYER3 (refer to the Layer 2 and Layer 3 LWAPP
Step 12
Operation chapter for an explanation of this setting).
Note
Enter the Virtual Gateway IP Address. This address can be any fictitious, unassigned IP address (such
Step 13
as 1.1.1.1) to be used by Layer 3 Security and Mobility managers.
Enter the Cisco WLAN Solution Mobility Group (RF group) name.
Step 14
Cisco Wireless LAN Controller Configuration Guide
4-4
9600 baud
8 data bits
1 stop bit
no parity
no hardware flow control
The controller in the Catalyst 3750G Integrated Wireless LAN Controller Switch operates only
in Layer 3 mode.
Chapter 4 Configuring Controller SettingsWireless Device Access
OL-9141-03