Cisco SD2008T-NA Configuration Manual page 310

Configuring Mobility Groups
Click Save Configuration to save your changes.
e.
Repeat
f.
Repeat this procedure on every controller to be included in the mobility group. All controllers in the
g.
mobility group must be configured with the MAC address and IP address of all other mobility group
members.
Step 4 The Mobility Group Members > Edit All page (see
mobility group name (optional) of all the controllers currently in the mobility group. The controllers are
listed one per line with the local controller at the top of the list.
Note
Figure 11-8 Mobility Group Members > Edit All Page
Follow these steps to add more controllers to the mobility group:
Click inside the edit box to start a new line.
a.
Enter the MAC address, the management interface IP address, and the name of the mobility group
b.
for the controller to be added.
Note
Note
Repeat
c.
Highlight and copy the complete list of entries in the edit box.
d.
Click Apply to commit your changes. The new controllers are added to the list of mobility group
e.
members on the Static Mobility Group Members page.
Cisco Wireless LAN Controller Configuration Guide
11-10
Step a through Step d
If desired, you can edit or delete any of the controllers in the list.
These values should be entered on one line and separated by one or two spaces.
The mobility group name is case sensitive.
Step a and Step b for each additional controller that you want to add to the mobility group.
Chapter 11 Configuring Mobility GroupsWireless Device Access
to add all of the controllers in the mobility group.
Figure 11-8) lists the MAC address, IP address, and
OL-9141-03