Cisco SD2008T-NA Configuration Manual page 140

Configuring Access Control Lists
When the Access Control Lists > Edit page appears, click Add New Rule. The Access Control Lists >
Step 5
Rules > New page appears (see
Figure 5-4
Follow these steps to configure a rule for this ACL:
Step 6
The controller supports up to 64 rules for each ACL. These rules are listed in order from 1 to 64. In
a.
the Sequence field, enter a value (between 1 and 64) to determine the order of this rule in relation
to any other rules defined for this ACL.
Note
From the Source drop-down box, choose one of these options to specify the source of the packets to
b.
which this ACL applies:
•
•
From the Destination drop-down box, choose one of these options to specify the destination of the
c.
packets to which this ACL applies:
•
•
From the Protocol drop-down box, choose the protocol to be used for this ACL. These are the
d.
protocol options:
•
•
•
•
•
Cisco Wireless LAN Controller Configuration Guide
5-10
Figure
Access Control Lists > Rules > New Page
If rules 1 through 4 are already defined and you add rule 29, it is added as rule 5. If you add
or change a sequence number for a rule, the sequence numbers for other rules adjust to
maintain a contiguous sequence. For instance, if you change a rule's sequence number from
7 to 5, the rules with sequence numbers 5 and 6 are automatically reassigned as 6 and 7,
respectively.
Any—Any source (This is the default value.)
IP Address—A specific source. If you choose this option, enter the IP address and netmask of
the source in the edit boxes.
Any—Any destination (This is the default value.)
IP Address—A specific destination. If you choose this option, enter the IP address and netmask
of the destination in the edit boxes.
Any—All protocol (This is the default value.)
TCP—Transmission Control Protocol
UDP—User Datagram Protocol
ICMP—Internet Control Message Protocol
ESP—IP Encapsulating Security Payload
5-4).
Chapter 5 Configuring Security Solutions
OL-9141-03