Using The Gui To Configure Ccx Radio Management - Cisco SD2008T-NA Configuration Manual

Configuring CCX Radio Management Features

Using the GUI to Configure CCX Radio Management

Follow these steps to configure CCX radio management using the controller GUI.
Click Wireless and then click Network under either 802.11a or 802.11b/g. The 802.11a (or 802.11b/g)
Step 1
Global Parameters page appears (see
Figure 10-10 802.11a Global Parameters Page
Under CCX Location Measurement, check the Mode check box to globally enable CCX radio
Step 2
management. This parameter causes the access points connected to this controller to issue broadcast
radio measurement requests to clients running CCX v2 or higher. The default value is disabled (or
unchecked).
If you checked the Mode check box in the previous step, enter a value in the Interval field to specify how
Step 3
often the access points are to issue the broadcast radio measurement requests.
Range: 60 to 32400 seconds
Default: 60 seconds
Click Apply to commit your changes.
Step 4
Step 5 Click Save Configuration to save your settings.
Cisco Wireless LAN Controller Configuration Guide
10-30
Chapter 10 Configuring Radio Resource ManagementWireless Device Access
Figure 10-10).
OL-1926-06OL-9141-03