Resetting The Device To Default Settings; Resetting To Default Settings Using The Cli; Resetting To Default Settings Using The Gui - Cisco SD2008T-NA Configuration Manual

Chapter 4 Configuring Controller SettingsWireless Device Access

Resetting the Device to Default Settings

If you need to start over during the initial setup process, you can reset the controller to factory default
settings.
Note After resetting the configuration to defaults, you need a serial connection to the controller to use the
configuration wizard.

Resetting to Default Settings Using the CLI

Follow these steps to reset the configuration to factory default settings using the CLI.
Step 1 Enter reset system. At the prompt that asks whether you need to save changes to the configuration, enter
Y or N. The unit reboots.
Step 2 When you are prompted for a username, enter recover-config to restore the factory default
configuration. The controller reboots and displays this message:
Welcome to the Cisco WLAN Solution Wizard Configuration Tool
Use the configuration wizard to enter configuration settings.
Step 3

Resetting to Default Settings Using the GUI

Follow these steps to return to default settings using the GUI.
Step 1 Open your Internet browser. The GUI is fully compatible with Microsoft Internet Explorer version 6.0
or later on Windows platforms.
Step 2 Enter the controller IP address in the browser address line and press Enter. An Enter Network Password
windows appears.
Step 3 Enter your username in the User Name field. The default username is admin.
Step 4 Enter the wireless device password in the Password field and press Enter. The default password is
admin.
Browse to the Commands > Reset to Factory Defaults page.
Step 5
Step 6 Click Reset. At the prompt, confirm the reset.
Step 7 Reboot the unit and do not save changes.
Use the configuration wizard to enter configuration settings.
Step 8
Ol-9141-03
Using the Configuration Wizard
Cisco Wireless LAN Controller Configuration Guide
4-3