Using The Cli To Enable Management Over Wireless; Configuring Dhcp Option 82 - Cisco SD2008T-NA Configuration Manual

Chapter 5 Configuring Security Solutions

Using the CLI to Enable Management over Wireless

In the CLI, use the show network command to verify whether the Mgmt Via Wireless Interface is
Step 1
Enabled or Disabled. If Mgmt Via Wireless Interface is Disabled, continue with Step 2. Otherwise,
continue with Step 3.
Step 2 To Enable Management over Wireless, enter config network mgmt-via-wireless enable.
Step 3 Use a wireless client to associate with an access point connected to the controller that you want to
manage.
Step 4 Enter telnet controller-ip-address and log into the CLI to verify that you can manage the WLAN using
a wireless client.

Configuring DHCP Option 82

DHCP option 82 provides additional security when DHCP is used to allocate network addresses.
Specifically, it enables the controller to act as a DHCP relay agent to prevent DHCP client requests from
untrusted sources. The controller can be configured to add option 82 information to DHCP requests from
clients before forwarding the requests to the DHCP server. See
process.
Figure 5-1
PC or PDA with 802.11
Client and IP Soft-Phone
The access point forwards all DHCP requests from a client to the controller. The controller adds the
DHCP option 82 payload and forwards the request to the DHCP server. The payload can contain the
MAC address or the MAC address and SSID of the access point, depending on how you configure this
option.
Note Any DHCP packets that already include a relay agent option are dropped at the controller.
DHCP option 82 is not supported for use with auto-anchor mobility, which is described in
Note
OL-9141-03
DHCP Option 82
and forwards it to DHCP Server
Access
Point
802.11 WLAN
IP Phone
Controller adds Option 82
payload to the request
DHCP
Relay Agent
(Controller)
Cisco Wireless LAN Controller Configuration Guide
Configuring DHCP Option 82
Figure 5-1 for an illustration of this
IP
DHCP
Server
Chapter 11.
5-7