Cisco SD2008T-NA Configuration Manual page 226

Cisco Aironet 1510 Series Lightweight Outdoor Mesh Access Points
Note
From the Bridge Data Rate drop-down box, choose a value (in Mbps) for the rate at which data is shared
Step 6
between access points on the backhaul interface. The default value is 18 Mbps for the 802.11a backhaul
interface.
Click Apply to commit your changes.
Step 7
Click Save Configuration to save your changes.
Step 8
Using the CLI to Configure Bridging Parameters
Follow these steps to configure bridging parameters using the controller CLI.
To specify that your AP1510 has bridge functionality, enter this command:
Step 1
config ap mode bridge Cisco_AP
To specify the role of this access point in the mesh network, enter this command:
Step 2
config ap role {rootAP | meshAP} Cisco_AP
Use the meshAP parameter if the AP1510 has a wireless connection to the controller (this is the default
setting in software release 4.0), or use the rootAP parameter if the AP1510 has a wired connection to
the controller.
Note
To assign this AP1510 to a bridge group, enter this command:
Step 3
config ap bridgegroupname set groupname Cisco_AP
To specify the rate (in Kbps) at which data is shared between access points on the backhaul interface,
Step 4
enter this command:
config ap bhrate rate Cisco_AP
The default value is 18 Kbps for the 802.11a backhaul interface.
To save your settings, enter this command:
Step 5
save config
Cisco Wireless LAN Controller Configuration Guide
7-18
You must enable bridging on all access points for which you want to allow bridging, including
the RAP. Therefore, if you want to allow an Ethernet on a MAP to bridge to the RAP's Ethernet,
you must enable bridging on the RAP as well as the MAP.
If you upgrade to software release 4.0 from a previous release, your root access points default to
the meshAP role. You must reconfigure them for the rootAP role.
Chapter 7 Controlling Lightweight Access Points
OL-9141-03