Enabling Wireless Connections To The Web-Browser And Cli Interfaces - Cisco SD2008T-NA Configuration Manual

Chapter 2 Using the Web-Browser and CLI Interfaces
Enabling Wireless Connections to the Web-Browser and
CLI Interfaces
You can monitor and configure controllers using a wireless client. This feature is supported for all
management tasks except uploads from and downloads to the controller.
Before you can open the GUI or the CLI from a wireless client device you must configure the controller
to allow the connection. Follow these steps to enable wireless connections to the GUI or CLI:
Log into the CLI.
Step 1
Enter config network mgmt-via-wireless enable
Step 2
Use a wireless client to associate to a lightweight access point connected to the controller.
Step 3
On the wireless client, open a Telnet session to the controller, or browse to the controller GUI.
Step 4
To use the controller GUI to enable wireless connections, browse to the Management Via Wireless page
Tip
and select the Enable Controller Management to be accessible from Wireless Clients check box.
OL-9141-03
Cisco Wireless LAN Controller Configuration GuideCisco Access Router Wireless Configuration Guide

Enabling Wireless Connections to the Web-Browser and CLI Interfaces

2-9