Enabling Link Aggregation
Using the GUI to Enable Link Aggregation
Follow these steps to enable LAG on your controller using the GUI.
Click Controller > General to access the General page (see
Step 1
Figure 3-13
Set the LAG Mode on Next Reboot parameter to Enabled.
Step 2
Note
Click Apply to commit your changes.
Step 3
Click Save Configuration to save your changes.
Step 4
Reboot the controller.
Step 5
Step 6
Assign the WLAN to the appropriate VLAN.
Cisco Wireless LAN Controller Configuration Guide
3-34
General Page
Choose Disabled if you want to disable LAG. LAG is disabled by default on the Cisco 4400
series controllers but enabled by default on the Cisco WiSM.
Chapter 3
Configuring Ports and Interfaces
Figure
3-13).
OL-9141-03