Chapter 11
Configuring Mobility GroupsWireless Device Access
This page shows the mobility group name in the Default Mobility Group field and lists the MAC address
and IP address of each controller that is currently a member of the mobility group. The first entry is the
local controller, which cannot be deleted.
Note
Step 2
Perform one of the following to add controllers to a mobility group:
•
If you are adding only one controller or want to individually add multiple controllers, click New and
go to
If you are adding multiple controllers and want to add them in bulk, click EditAll and go to
•
Note
The Mobility Group Member > New page appears (see
Step 3
Figure 11-7 Mobility Group Member > New Page
Follow these steps to add a controller to the mobility group:
In the Member IP Address field, enter the management interface IP address of the controller to be
a.
added.
In the Member MAC Address field, enter the MAC address of the controller to be added.
b.
In the Group Name field, enter the name of the mobility group.
c.
Note
Click Apply to commit your changes. The new controller is added to the list of mobility group
d.
members on the Static Mobility Group Members page.
OL-9141-03
Click Remove if you want to delete any of the remote controllers from the mobility group.
Step
3.
The EditAll option enables you to enter the MAC and IP addresses of all the current mobility
group members and then copy and paste all the entries from one controller to the other controllers
in the mobility group.
The mobility group name is case sensitive.
Figure
11-7).
Cisco Wireless LAN Controller Configuration Guide
Configuring Mobility Groups
Step
4.
11-9