Cisco SD2008T-NA Configuration Manual page 185

Chapter 6 Configuring WLANsWireless Device Access
Click the Edit link for the desired WLAN to access the WLANs > Edit page (see
Step 3
Figure 6-2
Uncheck the Admin Status check box, if checked, to disable this WLAN and click Apply.
Step 4
Under Security Policies, choose CKIP from the Layer 2 Security drop-down box.
Step 5
Under CKIP Parameters, choose the length of the CKIP encryption key from the Key Size drop-down
Step 6
box.
Range: Not Set, 40 bits, or 104 bits
Default: Not Set
Choose the number to be assigned to this key from the Key Index drop-down box. You can configure up
Step 7
to four keys.
Choose ASCII or HEX from the Key Format drop-down box and then enter an encryption key in the
Step 8
Encryption Key field. 40-bit keys must contain 5 ASCII text characters or 10 hexadecimal characters.
104-bit keys must contain 13 ASCII text characters or 26 hexadecimal characters.
OL-1926-06OL-9141-03
WLANs > Edit Page
Cisco Wireless LAN Controller Configuration Guide
Configuring WLANs
Figure 6-1).
6-13