Using The Cli To Enable System Logging - Cisco SD2008T-NA Configuration Manual

Chapter 4 Configuring Controller SettingsWireless Device Access
Figure 4-6

Using the CLI to Enable System Logging

Follow these steps to enable system logging through the controller CLI.
Enter config syslog ip_address to enable system logging and set the IP address of the Syslog server.
Step 1
Enter config msglog level msg_level to set the logging level.
Step 2
For msg_level, you can enter one of the following five values:
•
•
•
•
•
To view the current syslog status, enter show syslog. To view the message logs, enter show msglog.
Step 3
Ol-9141-03
Message Logs Page
critical—Critical hardware or software failure
error—Non-critical software errors
security—Authentication- or security-related errors
warning—Unexpected software events
verbose—Significant system events
Cisco Wireless LAN Controller Configuration Guide
Enabling System Logging
4-15