Web-Based Authentication; Local Netuser - Cisco SD2008T-NA Configuration Manual

Configuring WLANs
Figure 6-4
Click Save Configuration.
Step 6
Using the CLI to Configure VPN Passthrough
Enter this command to enable VPN Passthrough for a WLAN using the controller CLI.
•

Web-Based Authentication

Web authentication is simple to set up and use and can be used with SSL to improve the overall security
of the WLAN. The use of Web authentication requires Microsoft Internet Explorer with Active Scripts
enabled. Enter these commands to enable web authentication for a WLAN:
•
•

Local Netuser

Controllers have built-in network client authentication capability, similar to that provided by a RADIUS
authentication server. Enter these commands to create a list of usernames and passwords allowed access
to the WLAN:
•
•
Cisco Wireless LAN Controller Configuration Guide
6-16
WLANs > Edit Page (bottom)
config wlan security passthru {enable | disable} wlan-id gateway
– For gateway, enter the IP address of the router that is terminating the VPN tunnel.
– Enter show wlan to verify that the passthrough is enabled.
config wlan security web {enable | disable} wlan-id
Enter show wlan to verify that web authentication is enabled.
Enter show netuser to display client names assigned to WLANs.
Enter config netuser add username password wlan-id to add a user to a WLAN.
Chapter 6 Configuring WLANsWireless Device Access
OL-1926-06OL-9141-03