Using The Cli To Configure Voice Parameters - Cisco SD2008T-NA Configuration Manual

Configuring Voice and Video Parameters
c.
Figure 4-16

Using the CLI to Configure Voice Parameters

Follow these steps to configure voice parameters using the CLI.
Make sure that the WLAN is configured for WMM and the QoS level is set to Platinum. See
Step 1
"Configuring Quality of Service" section on page 6-17
Step 2 To disable the radio network, enter this command:
config {802.11a | 802.11b} disable network
To save your settings, enter this command:
Step 3
save config
Cisco Wireless LAN Controller Configuration Guide
4-30
Click the Detail link for the desired client to access the AP > Clients > Traffic Stream Metrics page
(see Figure 4-16).
AP > Clients > Traffic Stream Metrics Page
This page shows the TSM statistics for this access point and a client associated to it. The statistics
are shown in 90-second intervals. The timestamp field shows the specific interval when the statistics
were collected.
Chapter 4 Configuring Controller SettingsWireless Device Access
for instructions.
OL-9141-03