Cisco SD2008T-NA Configuration Manual page 182

Configuring WLANs
Figure 6-1
Under Security Policies, choose WPA1+WPA2 from the Layer 2 Security drop-down box.
Step 3
Under WPA1+WPA2 Parameters, check the WPA1 Policy check box to enable WPA1, check the WPA2
Step 4
Policy check box to enable WPA2, or check both check boxes to enable both WPA1 and WPA2.
Note
Check the AES check box to enable AES data encryption or the TKIP check box to enable TKIP data
Step 5
encryption for WPA1, WPA2, or both. The default values are TKIP for WPA1 and AES for WPA2.
Step 6 Choose one of the following key management methods from the Auth Key Mgmt drop-down box:
802.1X, CCKM, PSK, or 802.1X+CCKM.
Cisco Wireless LAN Controller Configuration Guide
6-10
WLANs > Edit Page
The default value is disabled for both WPA1 and WPA2. If you leave both WPA1 and WPA2
disabled, the access points advertise in their beacons and probe responses information elements
only for the authentication key management method you choose in
Chapter 6 Configuring WLANsWireless Device Access
Step 6.
OL-1926-06OL-9141-03