Cisco SD2008T-NA Configuration Manual page 146

Configuring Management Frame Protection
Figure 5-7
On this page, you can see the following MFP settings:
The Management Frame Protection field shows if MFP is enabled globally for the controller.
•
The Controller Time Source Valid field indicates whether the controller time is set locally (by
•
manually entering the time) or through an external source (such as NTP server). If the time is set by
an external source, the value of this field is "True." If the time is set locally, the value is "False."
The time source is used for validating management frames between access points of different
controllers that also have mobility configured.
• The MFP Protection field shows if MFP is enabled for individual WLANs.
• The MFP Validation field shows if MFP is enabled for individual access points.
Step 2 To see the current MFP state for a particular access point, click Wireless, 802.11a Radios or 802.11b/g
Radios under Access Points, and the Configure link of the desired access point. The 802.11a (or
802.11b/g) Cisco APs > Configure page appears (see
Cisco Wireless LAN Controller Configuration Guide
5-16
Management Frame Protection Settings Page
Chapter 5 Configuring Security Solutions
Figure 5-8).
OL-9141-03