Configuring WLANs
Using the GUI to View a Client's CCX Version
A client device sends its CCX version in association request packets to the access point. The controller
then stores the client's CCX version in its database and uses it to limit the features for this client. For
example, if a client supports CCX version 2, the controller does not allow the client to use CCX version
4 features. Follow these steps to see the CCX version supported by a particular client device using the
GUI.
Click Wireless > Clients to access the Clients page.
Step 1
Click the Detail link for the desired client device to access the Clients > Detail page (see
Step 2
Figure 6-7
The CCX Version field shows the CCX version supported by this client device. Not Supported appears
if the client does not support CCX.
Click Back to return to the previous screen.
Step 3
Repeat this procedure to view the CCX version supported by any other client devices.
Step 4
Using the CLI to Configure CCX Aironet IEs
To enable or disable support for Aironet IEs for a particular WLAN, enter this command:
config wlan ccx aironet-ie {enable | disable} wlan_id
The default value is enabled.
Cisco Wireless LAN Controller Configuration Guide
6-24
Clients > Detail Page
Chapter 6
Configuring WLANsWireless Device Access
Figure
6-7).
OL-1926-06OL-9141-03