Using The Cli To Configure The Controller For Hybrid Reap; Configuring An Access Point For Hybrid Reap; Using The Gui To Configure An Access Point For Hybrid Reap - Cisco SD2008T-NA Configuration Manual

Configuring Hybrid REAP

Using the CLI to Configure the Controller for Hybrid REAP

Use these commands to configure the controller for hybrid REAP:
•
•
Go to the
Note
three access points for hybrid REAP.
Use these commands to obtain hybrid-REAP information:
•
•
•
Use these commands to obtain debug information:
•
•
•
•
•
•

Configuring an Access Point for Hybrid REAP

This section provides instructions for configuring an access point for hybrid REAP using either the
controller GUI or CLI.

Using the GUI to Configure an Access Point for Hybrid REAP

Follow these steps to configure an access point for hybrid REAP using the controller GUI.
Make sure that the access point has been physically added to your network.
Step 1
Click Wireless to access the All APs page (see
Step 2
Cisco Wireless LAN Controller Configuration Guide
12-12
config wlan h-reap local-switch wlan-id enable—Configures the WLAN for local switching.
config wlan h-reap local-switch wlan-id disable—Configures the WLAN for central switching.
This is the default value.
"Configuring an Access Point for Hybrid REAP" section on page 12-12
show ap config general Cisco_AP—Shows VLAN configurations.
show wlan wlan_id—Shows whether the WLAN is locally or centrally switched.
show client detail client_mac—Shows whether the client is locally or centrally switched.
debug lwapp events enable—Provides debug information on LWAPP events.
debug lwapp error enable—Provides debug information on LWAPP errors.
debug pem state enable—Provides debug information on the policy manager State Machine.
debug pem events enable—Provides debug information on policy manager events.
debug dhcp packet enable—Provides debug information on DHCP packets.
debug dhcp message enable—Provides debug information on DHCP error messages.
Chapter 12 Configuring Hybrid REAPWireless Device Access
Figure 12-7).
to configure two or
OL-9141-03