Wincor Nixdorf Rs232 Mode A; Rs232 Modifiers - Honeywell 1602-B User Manual

Wincor Nixdorf RS232 Mode A

This interface is only appropriate for an Access Point. Scan the following Plug and Play code to program the scanner for a
Wincor Nixdorf RS232 Mode A terminal, then power cycle the host. This bar code sets the baud rate to 9600 bps and the
data format to 8 data bits, odd parity, 1 stop bit. The following prefixes are programmed for each symbology:

RS232 Modifiers

The following RS232 settings should only be used when connecting through an Access Point.
RS232 Baud Rate
Baud Rate sends the data from the scanner to the terminal at the specified rate. The host terminal must be set for the
same baud rate as the scanner. Default = 115,200.
2 - 18
The HEC and TEC codes identified in this watermark supersede any conflicting HEC or TEC codes displayed in the drawing.
Wincor Nixdorf RS232 Mode A
300
1200
4800
19200
Settings
600
2400
9600