Host Ack Timeout - Honeywell 1602-B User Manual

Host ACK On/Off
Host ACK On

Host ACK Timeout

You can set a timeout for the length of time the scanner waits for a valid escape command when using Host Acknowledg-
ment Mode. Set the length (in seconds) for a timeout by scanning the following bar code, then setting the timeout (from 1-
90 seconds) by scanning digits from the
Default = 10.
Host ACK Responses
Command
[ESC] a,
[ESC] b,
[ESC] 1,
[ESC] 2,
[ESC] 3,
[ESC] 4,
[ESC] 5,
[ESC] 6,
[ESC] 7,
[ESC] 8,[ESC] 8,
3 - 22
The HEC and TEC codes identified in this watermark supersede any conflicting HEC or TEC codes displayed in the drawing.
Programming Chart inside the back cover of this manual, then scanning Save.
Host ACK Timeout
Action
Double beeps to indicate a successful menu change was made.
Razz or error tone to indicate a menu change was unsuccessful.
The green LED illuminates for 135 milliseconds followed by a pause.
The green LED illuminates for 2 seconds followed by a pause.
The green LED illuminates for 5 seconds followed by a pause.
Emits a beep at a low pitch.
Emits a beep at a medium pitch.
Emits a beep at a high pitch.
Beeps to indicate a successful decode and communication to host.
Razz or error tone to indicate a decode/communication to host was unsuccessful.
* Host ACK Off