Charging With A Pc; Battery Charge Indicator - Honeywell 1602-B User Manual

Charging with a PC

Charging your scanner battery through the USB port of a computer will take longer than charging with an electrical outlet.
Connect the mini-USB connector to the scanner and the USB connector to the computer, as shown below.
Note: The mini-USB connector is only used for charging the scanner. If using a scanner in corded mode, it can also be
used to configure the device via EZConfig (see page

Battery Charge Indicator

When the battery is charging, the small LED at the top left of the scanner flashes orange. When the battery is fully
charged, this LED is solid green. Refer to
3-6) for the complete list of LED indications.
To use your scanner with a Honeywell Access Point (AP01-XXXBT), refer to
Scanner to an Access
1 - 2
The HEC and TEC codes identified in this watermark supersede any conflicting HEC or TEC codes displayed in the drawing.
Scan LED Sequences and Meaning
Point, page 3-13.
8-3 for further information).
(page 3-6) and
Host ACK Responses, page 3-22 or
Low Battery Indicator (page
Linking the