Flexible Power Management; Multiple Scanner Operation; Scanner Name - Honeywell 1602-B User Manual

Note: When the scanner is in power down mode, press the scan button to power the unit back up. There will be a set of power
up beeps and a delay of up to a few seconds for the radio to join. The scanner will then be ready to use.

Flexible Power Management

If you are experiencing network performance issues, and suspect the scanner is interfering with other devices, you can turn
down the power output of the scanner. This reduces the range between the scanner and a host as shown in the following illus-
tration:
Scan one of the bar codes below to set the scanner's power output to Full Power (100%), Medium Power (35%), Medium Low
Power (5%), or Low Power (1%). Default = Full Power.
* Full Power
Medium Low Power

Multiple Scanner Operation

Note: Multiple Scanner Operation Mode allows you to link up to 7 scanners to one Access Point. You cannot join an 8th scanner
until you unlink one of the 7 scanners or take a scanner out of range.
To put the scanner in multiple scanner mode, scan the bar code below. Once you scan this bar code, the scanner is unlinked
from the current host and must be paired with a host to relink.

Scanner Name

You may assign a name to each scanner you are using for identification purposes. For example, you may want to have a unique
identifier for a scanner that is receiving specific commands sent from the host.
3 - 10
The HEC and TEC codes identified in this watermark supersede any conflicting HEC or TEC codes displayed in the drawing.
802.11
Scanner
LAN
Multiple Scanner Operation
Medium Power
Low Power