Delete Last Code; Clear All Codes; Transmit Records To Host; Batch Mode Transmit Delay - Honeywell 1602-B User Manual

Delete Last Code

If you want to delete the last bar code scanned when in Batch Mode, scan Delete Last Code.
Delete Last Code

Clear All Codes

If you want to clear the scanner's buffer of all data accumulated in Batch Mode, scan Clear All Codes.
Clear All Codes

Transmit Records to Host

If you are operating in Inventory Batch Mode (see Inventory Batch Mode on page 3-16), you must scan the following bar
code to transmit all the stored data to the host system.
Transmit Inventory Records

Batch Mode Transmit Delay

Sometimes when accumulated scans are sent to the host system, the transmission of those scans is too fast for the appli-
cation to process. To program a transmit delay between accumulated scans, scan one of the following delays. Default =
Off.
Note: In most cases, a short (250 ms (milliseconds)) delay is ideal, however, longer delays may be programmed. Contact
Technical Support (page -ix) for additional information.
* Batch Mode Transmit Delay Off
(No Delay)
Batch Mode Transmit Delay Short
(250 ms)
Batch Mode Transmit Delay Medium
(500 ms)
Batch Mode Transmit Delay Long
(1000 ms)
3 - 20
The HEC and TEC codes identified in this watermark supersede any conflicting HEC or TEC codes displayed in the drawing.