Chapter 2 - Programming The Interface; Introduction; Keyboard Country Layout - Honeywell 1602-B User Manual

2
Programming the Interface

Introduction

This chapter describes how to program your scanner for different keyboards and settings, and for an interface when using an
Access Point (see Programming an Interface for an Access Point, beginning on page 2-12). The VG1602g is primarily designed
as a cordless scanner. However, if you are using the VG1602g as a corded scanner, see Programming the VG1602 Corded
Interface beginning on page 2-23.

Keyboard Country Layout

If your interface is USB Keyboard or Keyboard Wedge through an Access Point, or a Bluetooth Keyboard, your keyboard layout
default is a US keyboard. To change this layout, refer to the chart below for your keyboard country. Scan the appropriate bar
code below to change the layout.
By default, national character replacements are used for the following characters: #$@[\]^'{|}~ See ISO 2022/ISO 646
Character Replacements on page A-7 to view the character replacements for each country.
Keyboard Countries
* United States
Albania
Azeri (Cyrillic)
Azeri (Latin)
Belarus
Belgium
Bosnia
Brazil
2 - 1
The HEC and TEC codes identified in this watermark supersede any conflicting HEC or TEC codes displayed in the drawing.