Character Activation Mode; Activation Character; End Character Activation After Good Read - Honeywell 1602-B User Manual

Character Activation Mode

You may use a character sent from the host to trigger the scanner to begin scanning. When the activation character is received,
the scanner continues scanning until either the
(see Deactivation Character
vation, then use Activation Character (following) to select the character you will send from the host to start scanning. Default =
Off.
* Off

Activation Character

This sets the character used to trigger scanning when using Character Activation Mode. On the
(Code Page 1252), page A-3, find the hex value that represents the character you want to use to trigger scanning. Scan
the following bar code, then use the
character. Scan Save to finish. Default = 12 [DC2].

End Character Activation After Good Read

After a bar code is successfully detected and read from the scanner, the illumination can be programmed either to remain
on and scanning, or to turn off. When End Character Activation After Good Read is enabled, the illumination turns off
and stops scanning after a good read. If you scan Do Not End Character Activation After Good Read, the illumination
remains on after a good read. Default = Do Not End Character Activation After Good Read.
* Do Not End Character
Activation After Good Read
4 - 10
The HEC and TEC codes identified in this watermark supersede any conflicting HEC or TEC codes displayed in the drawing.
Character Activation Timeout
on page 4-11), or a bar code is transmitted. Scan the following On bar code to use character acti-
Programming Chart
Activation Character
(page 4-11), the deactivation character is received
to read the alphanumeric combination that represents that ASCII
On
ASCII Conversion Chart
End Character Activation After
Good Read