Character Activation Timeout; Character Deactivation Mode; Deactivation Character; Illumination Lights - Honeywell 1602-B User Manual

Character Activation Timeout

You can set a timeout for the length of time the illumination remains on and attempting to decode bar codes when using
Character Activation Mode. Set the length (in milliseconds) for a timeout by scanning the following bar code, then setting
the timeout (from 1-300,000 milliseconds) by scanning digits from the
manual, then scanning Save. Default = 30,000 ms.

Character Deactivation Mode

If you have sent a character from the host to trigger the scanner to begin scanning, you can also send a deactivation character
to stop scanning. Scan the following On bar code to use character deactivation, then use Deactivation Character (following) to
select the character you will send from the host to terminate scanning. Default = Off.
* Off

Deactivation Character

This sets the character used to terminate scanning when using Character Deactivation Mode. On the
Chart (Code Page
Scan the following bar code, then use the
meric combination that represents that ASCII character. Scan

Illumination Lights

If you want the illumination lights on while reading a bar code, scan the Lights On bar code, below. However, if you want to turn
just the lights off, scan the Lights Off bar code. Default = Lights On.
Note: This setting does not affect the aimer light. The aiming light can be set using
* Lights On
The HEC and TEC codes identified in this watermark supersede any conflicting HEC or TEC codes displayed in the drawing.
Character Activation Timeout
1252), page A-3, find the hex value that represents the character you want to use to terminate scanning.
Programming Chart
Programming Chart
inside the back cover of this manual to read the alphanu-
Save to finish. Default = 14 [DC4].
Deactivation Character
inside the back cover of this
On
ASCII Conversion
Aimer Mode (page 4-12).
Lights Off
4 - 11