Usb Hid; Usb Serial; Remote Mastermind™ For Usb - Honeywell 1602-B User Manual

USB HID

Scan the following code to program the scanner for USB HID bar code scanners, then power cycle the host. This interface
is only appropriate for an Access Point.

USB Serial

This interface is only appropriate for an Access Point. Scan the following code to program the scanner to emulate a regular
RS232-based COM Port, then power cycle the host. If you are using a Microsoft® Windows® PC, you will need to down-
load a driver from the Honeywell website (www.honeywellaidc.com). The driver will use the next available COM Port num-
ber. Apple® Macintosh computers recognize the scanner as a USB CDC class device and automatically use a class driver.
Note: No extra configuration (e.g., baud rate) is necessary.
CTS/RTS Emulation
CTS/RTS Emulation On
ACK/NAK Mode
ACK/NAK Mode On
Remote MasterMind™ for USB
When using a USB interface, you may wish to configure your scanner to communicate with Remote MasterMind Scanner
Management Software (ReM). Scan the ReM On bar code to communicate with ReM. To disable this capability, scan ReM
Off. This interface is only appropriate for an Access Point.
ReM Off
The HEC and TEC codes identified in this watermark supersede any conflicting HEC or TEC codes displayed in the drawing.
USB HID Bar Code Scanner
USB Serial
* CTS/RTS Emulation Off
* ACK/NAK Mode Off
2 - 15