Chapter 8 - Utilities; To Add A Test Code I.d. Prefix To All Symbologies; Show Decoder Revision; Show Scan Driver Revision - Honeywell 1602-B User Manual

8
Utilities

To Add a Test Code I.D. Prefix to All Symbologies

This selection allows you to turn on transmission of a Code I.D. before the decoded symbology. (See the Symbology Charts,
beginning on page A-1) for the single character code that identifies each symbology.) This action first clears all current prefixes,
then programs a Code I.D. prefix for all symbologies. This is a temporary setting that will be removed when the unit is power
cycled.
Add Code I.D. Prefix to
All Symbologies (Temporary)

Show Decoder Revision

Scan the bar code below to output the decoder revision.
Show Decoder Revision

Show Scan Driver Revision

Scan the bar code below to output the scan driver revision.
Show Scan Driver Revision

Show Software Revision

Scan the bar code below to output the current software revision, unit serial number, and other product information.
Show Software Revision

Show Data Format

Scan the bar code below to show current data format settings.
DFMBK3?.
Data Format Settings
8 - 1
The HEC and TEC codes identified in this watermark supersede any conflicting HEC or TEC codes displayed in the drawing.