Other Programming Selections - Honeywell 1602-B User Manual

Step 5. Length
Specify what length (up to 9999 characters) of data will be acceptable for this symbology. Scan the four digit data length
from the Programming Chart
Note: 9999 indicates all lengths.
Step 6. Editor Commands
Refer to Data Format Editor Commands
Step 7. Scan Save to save your data format, or Discard to exit without saving your changes.
Enter Data Format
Discard

Other Programming Selections

Clear One Data Format
This deletes one data format for one symbology. If you are clearing the primary format, scan 0 from the
Chart inside the back cover of this manual. If you are clearing an alternate format, scan 1, 2, or 3, depending on the
format you are clearing. Scan the Terminal Type and Code I.D. (see
data length for the specific data format that you want to delete. All other formats remain unaffected.
Clear all Data Formats
This clears all data formats.
Save to exit and save your data format changes.
Discard to exit without saving any data format changes.
Clear One Data Format
Save
6 - 2
The HEC and TEC codes identified in this watermark supersede any conflicting HEC or TEC codes displayed in the drawing.
inside the back cover of this manual. For example, 50 characters is entered as 0050.
(page 6-3). Scan the symbols that represent the command you want to enter.
Symbology Charts on page A-1), and the bar code
Clear All Data Formats
Save
Programming
Discard