Table of Contents
Advertisement
2. Install optional PMC module(s) per manufacturers instructions (see "PMC Sites" on
page 4-14 for restrictions).
3. Configure the PMC VIO using VIO configuration jumpers P9, P12 (see "PCI VIO Select
(P9, P12)" on page 2-2).
4. Install the C2K in a 6U C-style CompactPCI-compliant chassis.
5. Slide the C2K into the slot guide, applying even pressure to the upper and lower extraction
handles. Be careful not to bend connector pins.
NOTE: The C-style C2K is Hot Swap-compliant and can be installed in and removed from
a powered-on Hot Swap-compliant chassis.
After sliding the C2K in the slot guide until the card engages the pins, wait for the blue
front-panel Hot Swap LED to turn off before closing the ejector handle switch (bottom
ejector handle).
6. Push up on the lower extraction handle and down on the upper handle to seat the Compact-
PCI connectors in the backplane connectors. The red tab on the extraction handles should
"click" when the board is locked into the chassis.
7. Tighten the small phillips-head screws embedded in the upper and lower extraction handles
to secure the C2K to the chassis.
8. Apply power to the chassis.
NOTE: C2K can be installed in a system controller or peripheral slot. If the C2K is not installed
in a system slot, a system controller card must be installed in the system slot to supply a PCI ref-
erence clock to C2K.
2.5.2 C2K N-style Installation
1. Remove the C2K SBC from the static-safe envelope (see "E.S.D. Caution" on page 2-1).
2. Install optional PMC module(s) per manufacturers instructions (see "PMC Sites" on
page 4-14 for restrictions).
3. Configure the PMC VIO using VIO configuration jumpers P9, P12 (see "PCI VIO Select
(P9, P12)" on page 2-2).
4. Install the C2K in a 6U N-style CompactPCI-compliant chassis.
5. Slide the C2K into the slot guide, applying even pressure to the upper and lower extraction
handles. Be careful not to bend connector pins.
6. Tighten upper and lower Wedge-Loks™ to 115inch/ounces using a 3/32-inch hex driver.
This secures the C2K in the system chassis and ensures proper heat conduction. Do not
overtighten.
7. Apply power to the chassis.
NOTE: C2K can be installed in a system controller or peripheral slot. If the C2K is not installed
in a system slot, a system controller card must be installed in the system slot to supply a PCI ref-
erence clock to C2K.
C2K User's Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Installation
2-4
Advertisement
Table of Contents
