GE C2K Hardware Reference Manual page 11

C2K Transition Module
GEIP offers an optional C2K Transition Module (C2K-TM) with the following on-board and
rear-panel connections:
• BATT+ (P13)—on-board 2 x 5 connector
• ETH0 (J6)—rear-panel RJ-45 connector
• ETH1 (J7)—rear-panel RJ-45 connector
• ETH2 (J8)—rear-panel RJ-45 connector
• GPIO connector (P14)—on-board 2 x 10-pin header
• ICMB interface (P17)—on-board 2 x 5-pin header
• Misc. Control header (P18)—on-board 2 x 5-pin header
• PMC0 I/O (P11)—on-board 2 x 32-pin header
• PMC1 I/O (P12)—on-board 2 x 32-pin header
• Reset switch, (S1)—rear-panel manual hardware reset micro-switch
• SATA1 (P19)—rear-panel connector
• SATA2 (P20)—rear-panel connector
• Serial I/O: COM1, COM2 RS-232 (P15, P16)—rear-panel DB9 connectors
• Serial I/O: COM3, COM4 RS-232 (P10, P9)—on-board 2 x 5-pin headers
• Serial I/O: COM1–COM4 RS-422 (P1–P4)—on-board 2 x 5-pin headers
• Serial I/O: COM5–COM8 RS-485 (P5–P8)—on-board 2 x 5-pin headers
• USB1 (J9)—rear-panel Type A USB connector
• USB2 (J10)—rear-panel Type A USB connector
• USB3 (J11)—rear-panel Type A USB connector
1-2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Introduction
C2K User's Guide